Choosing an Octave Edge Device

Use the table below to select an Octave edge device based on the goal(s) for your Octave deployment.

Goal	Protocol	Octave Device
Prototype with a ready-to-use device - Connect the asset over serial interface with supported protocols.	- Modbus (485/232) - CanOpen - Specific Protocol (485/232) - ORP (Octave Resource Protocol) if you can adapt the asset's controller	FX30S
Prototype with a ready-to-use device - Connect the asset over Ethernet with Modbus protocol.	Modbus	FX30
Prototype with a ready-to-use device - Connect the asset with GPIO.	Digital In/Out and analog in (ADC)	FX30 or FX30S
Build a Proof-of-Concept of your hardware design integrating the WP module with preloaded sensors and connect the asset over a serial interface or GPIO	- Modbus (485/232) - Specific Protocol (485/232) - ORP (Octave Resource Protocol) if you can adapt the asset's controller - Digital In/Out and Analog in (ADC)	mangOH Yellow Evaluation Kit Note: Mangoh Yellow dedicated builds are only provided up to Octave 3.1.0. For features requiring newer Octave Firmware, we recommend using the WP7702 firmware on the MangOH Yellows to build your proof of concept.

Getting Started Guides

After you have selected a device, you can then use the respective getting started guide to get up and running: